Download 6.5.1.2 Lab Building a Switch and Router Network PDF

Title6.5.1.2 Lab Building a Switch and Router Network
File Size191.8 KB
Total Pages5
Table of Contents
                            Part 1: Set Up Topology and Initialize Devices
Part 2: Configure Devices and Verify Connectivity
Part 3: Display Device Information
                        
Document Text Contents
Page 2

Lab - Building a Switch and Router Network

 Console cables to configure the Cisco IOS devices via the console ports

 Ethernet cables as shown in the topology

Note: The Gigabit Ethernet interfaces on Cisco 1941 routers are autosensing and an Ethernet straight-
through cable may be used between the router and PC-B. If using another model Cisco router, it may be
necessary to use an Ethernet crossover cable.

Part 1: Set Up Topology and Initialize Devices

Step 1: Cable the network as shown in the topology.

a. Attach the devices shown in the topology diagram, and cable, as necessary.

b. Power on all the devices in the topology.

Step 2: Initialize and reload the router and switch.

If configuration files were previously saved on the router and switch, initialize and reload these devices back
to their basic configurations. For information on how to initialize and reload these devices, refer to Appendix
B.

Part 2: Configure Devices and Verify Connectivity
In Part 2, you will set up the network topology and configure basic settings, such as the interface IP
addresses, device access, and passwords. Refer to the Topology and Addressing Table at the beginning of
this lab for device names and address information.

Note: Appendix A provides configuration details for the steps in Part 2. You should attempt to complete Part 2
prior to reviewing this appendix.

Step 1: Assign static IP information to the PC interfaces.

a. Configure the IP address, subnet mask, and default gateway settings on PC-A.

b. Configure the IP address, subnet mask, and default gateway settings on PC-B.

c. Ping PC-B from a command prompt window on PC-A.

Why were the pings not successful?

Porque no se ha configurado el router.

Step 2: Configure the router.

a. Console into the router and enable privileged EXEC mode.

b. Enter configuration mode.

c. Assign a device name to the router.

d. Disable DNS lookup to prevent the router from attempting to translate incorrectly entered commands as
though they were host names.

e. Assign class as the privileged EXEC encrypted password.

f. Assign cisco as the console password and enable login.

g. Assign cisco as the VTY password and enable login.

h. Encrypt the clear text passwords.

i. Create a banner that warns anyone accessing the device that unauthorized access is prohibited.

© 2016 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2 of 5

Similer Documents